Hi there! Lisa here and I'm sharing another shaker similar to one I made for the Crafting of Hue Sponsorship Weekend so I could show you how I made this shaker using the paw die from the Huggable Critters die set!
I started by cutting the Bubble Box layer using the 2nd largest die in the set. I taped it in place and then took the paw die from the Huggable Critters set and taped it in the bottom left corner so I could run them through together and avoid an extra run through the Gemini. Then I took that piece and taped the paw die in place again and ran it through. Then one more time so the paws were hopping across the bubblebox. Once all three paws were cut out, I ran the entire thing through with a floral embossing folder.
Next I adhered acetate over the back of the die cut paws and added foam tape to create a well around the area I wanted to place my sequins and then additional tape to provide support for the Bubble Box layer. I filled the well with sequins... using my fine tweezers to flip them over so when the shaker was right side up, most of the sequins would be too!
And finally I placed the design paper that I wanted to show through the shaker windows over the back. I added adhesive to that and flipped the whole shaker element over onto my card front.
To finish it off, I used this cutie pie bunny from the Little Huggables set that I colored with my Copics.
And I added this cute sentiment also from the Little Huggables set... love all of the punny sentiments on this set!
A few sequins and done!
Thanks so much for stopping today! Hope you enjoyed your visit and that you'll come back for more inspiration soon! And should you need anything from the shop, I have this for you:
1 comment:
super cute Lisa!
Post a Comment